Seagate DiamondMax 21 Manual download pdf (Page 20)

14 DiamondMax 21 PATA Product Manual, Rev. B

2.8.1.1 Typical current profile

Figure 1 Typical 5V startup and operation current profile

Figure 2 Typical 12V startup and operation current profile

2.8.2 Conducted noise

Input noise ripple is measured at the host system power supply across an equivalent 80-ohm resistive load on

the +12 volt line or an equivalent 15-ohm resistive load on the +5 volt line.

• Using 12-volt power, the drive is expected to operate with a maximum of 120 mV peak-to-peak square-wave

injected noise at up to 10 MHz.

• Using 5-volt power, the drive is expected to operate with a maximum of 100 mV peak-to-peak square-wave

injected noise at up to 10 MHz.

Note. Equivalent resistance is calculated by dividing the nominal voltage by the typical RMS read/write

current.

2.8.3 Voltage tolerance

Voltage tolerance (including noise):

5V ± 5%

12V ± 10%

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 49 50

No comments

Seagate DiamondMax 21 Manual Page 20