Seagate Savvio 10K Manual download pdf (Page 9)

Savvio 10K.2 SAS Product Manual, Rev. E 3

3.0 Applicable standards and reference documentation

The drive has been developed as a system peripheral to the highest standards of design and construction. The

drive depends on its host equipment to provide adequate power and environment for optimum performance

and compliance with applicable industry and governmental regulations. Special attention must be given in the

areas of safety, power distribution, shielding, audible noise control, and temperature regulation. In particular,

the drive must be securely mounted to guarantee the specified performance characteristics. Mounting by bot-

tom holes must meet the requirements of Section 9.3.

3.1 Standards

The Savvio family complies with Seagate standards as noted in the appropriate sections of this manual and the

Seagate SAS Interface Manual, part number 100293071.

The Savvio disk drive is a UL recognized component per UL1950, CSA certified to CAN/CSA C22.2 No. 950-

95, and VDE or TUV certified to EN60950.

3.1.1 Electromagnetic compatibility

The drive, as delivered, is designed for system integration and installation into a suitable enclosure prior to

use. The drive is supplied as a subassembly and is not subject to Subpart B of Part 15 of the FCC Rules and

Regulations nor the Radio Interference Regulations of the Canadian Department of Communications.

The design characteristics of the drive serve to minimize radiation when installed in an enclosure that provides

reasonable shielding. The drive is capable of meeting the Class B limits of the FCC Rules and Regulations of

the Canadian Department of Communications when properly packaged; however, it is the user’s responsibility

to assure that the drive meets the appropriate EMI requirements in their system. Shielded I/O cables may be

required if the enclosure does not provide adequate shielding. If the I/O cables are external to the enclosure,

shielded cables should be used, with the shields grounded to the enclosure and to the host controller.

3.1.1.1 Electromagnetic susceptibility

As a component assembly, the drive is not required to meet any susceptibility performance requirements. It is

the responsibility of those integrating the drive within their systems to perform those tests required and design

their system to ensure that equipment operating in the same system as the drive or external to the system

does not adversely affect the performance of the drive. See Tables 12 and 13, DC power requirements.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 75 76

No comments

Seagate Savvio 10K Manual Page 9