MaxAttach NAS 4000Installation Guide
5Registering MaxAttachPlease register either online or by using the registration card that came with the unit. 1. To register online, insert the self-
83. Click on your new folder. It is currently not shared. To grant access, click oneither the SMB or NFS box. Verify the share name, and click Apply.
6.6 Manage Disk – Four Disk DrivesIf your unit has four disk drives, MaxAttach has a default disk configurationof a Mirrored Set of Spanned Disks. The
7Connecting a PC or Laptop to MaxAttach 1. Go to Network Neighborhood. The name of your workgroup should be displayedhere. If not, click on Entire Net
10Troubleshooting If you are having difficulty with the unit, please read this section. If you still need help,contact technical support at www.maxtor
3. If the Network light still does not go on, be sure you are hooked into a hub orswitch. Do not connect the cable directly to your PC or laptop, unle
11Determining the Status of Your UnitUse the LEDs on the front panel of the file server as cues that there may be a problemwith the current operating
Appendix A: DHCP Services1. If you are installing your unit into a network with DHCP services, (usually a networkwith a server), your unit will automa
MaxAttach NAS 4000Installation Guide
Contents1 Box Contents 12 Product Overview 1Unit Information 1Necessary Equipment for Installation 13 Installing the MaxAttach NAS 4000 Unit 2Connect
Technical Support is available at 1-800-4MAXTOR and at www.maxtor.com© 2000 Maxtor Corporation. All rights reserved. Maxtor is a registered trademark
MaxAttach NAS 4000 Installation Guide1Box ContentsThe MaxAttach™NAS 4000 box contains: ❍MaxAttach NAS 4000 Network Storage Appliance ❍Quick Start Gui
23Installing the MaxAttach NAS 4000 Unit3.1 Connect MaxAttach to Your Network1. To connect the MaxAttach unit to the network, insert the cable that ca
33. When the installation is complete, you will be given the option to launch.To launch, click FINISH. A MaxNeighborhood window will appear with a“SEA
44.1 Setting the Clock 1. Fill in the fields as directed. If you have any questions, click Help. 2. If you and the unit are not located in the same ti
54.3 Assigning a Unit Name and Workgroup1. Enter a name for your unit, so users can find it in the Network Neighborhoodor Windows Explorer. When creat
64. When the reboot is done, you will be asked to enter your password. Enter it,then press the Enter key or click OK. Your unit in now ready for use.
Comments to this Manuals