Seagate ST3250310SV - 250GB 7200RPM Sata Surveillanc User Manual Page 112

  • Download
  • Add to my manuals
  • Print
  • Page
    / 163
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 111
96
Figure 7-34
Please refer to the following sheet for detailed information.
Parameter Function
IP Version
There are two options: IPv4 and IPv6. Right now, system
supports these two IP address format and you can access via
them.
DHCP It is to auto search IP. When enable DHCP function, you can
not modify IP/Subnet mask /Gateway. These values are from
DHCP function. If you have not enabled DHCP function,
IP/Subnet mask/Gateway display as zero. You need to
disable DHCP function to view current IP information.
Besides, when PPPoE is operating, you can not modify
IP/Subnet mask /Gateway.
MAC address
The host in the LAN can get a unique MAC address. It is for yo
to access in the LAN. It is read-only.
IP address Please input the corresponding number to set the IP address.
Then you can set the corresponding subnet mask and
gateway.
Subnet prefix The value ranges from 0 to 128. It is to mark a specified
network MAC. Usually it includes a structure of multiple-
layers.
Please note system needs to check the validity of all IPv6
addresses. The IP address and the default gateway shall be in
the same IP section. That is to say, the specified length of the
subnet prefix shall have the same string.
TCP Port Default value is 37777. You can change if necessary.
HTTP Port Default value is 554.
UDP Port Default value is 37778. You can change if necessary.
Max Connection Network user max amount. The value ranges from 0 to 20.
O means there is no user can access current device.
Remote
Host
Multiple
cast
group
z
Set MULCAST address and port.
z
Enable MULCAST function.
Page view 111
1 2 ... 107 108 109 110 111 112 113 114 115 116 117 ... 162 163

Comments to this Manuals

No comments