Seagate Ultra 160 User Manual Page 26
- Page / 186
- Table of contents
- BOOKMARKS
- Parallel SCSI Interface 1
- Revision status summary sheet 5
- Table of Contents 7
- List of Figures 13
- 1.0 Interface requirements 15
- standards 16
- 1.4 Summary of SCSI messages 26
- 2.0 SCSI bus 27
- 2.1 SCSI bus signals overview 29
- 2.2 Signal states 31
- 2.3 OR-tied signals 32
- 2.4 Signal sources 33
- 2.5 SCSI bus timing 34
- 0 0.5 0 0.2 39
- induced time asymmetry 39
- due to resis 43
- 2.6 Measurement points 47
- 2.9 Data transfer modes 51
- 2.12 Negotiation 53
- PPR, SDTR Less than or equal 55
- 2.12.4 Transfer agreements 56
- Table 13: Transfer agreements 56
- bit shall be set to zero 61
- Transfer 62
- 3.0 Logical characteristics 65
- 3.2 SELECTION phase 69
- 3.3 RESELECTION phase 72
- 3.4 SCSI bus fairness 73
- 3.6 COMMAND phase 89
- 3.7 DATA phase 89
- 3.8 STATUS phase 90
- 3.9 MESSAGE phase 90
- 3.11 SCSI bus phase sequences 92
- 3.12 Data bus protection 95
- 4.2 Message formats 97
- 4.3 Message categories 99
- 7 6 5 4 3 2 1 0 101
- 0 IDENTIFY DISCPRIV LUN 101
- Target’s Parallel Protocol 109
- 4.4 Task attribute messages 116
- 4.5 Task management messages 119
- 5.1 Attention condition 121
- 5.2 Bus reset condition 122
- 5.3 Hard reset 122
- 5.4 Reset events 123
- 6.0 SPI information units 127
- [3] See Figure 16 129
- [4] See Figure 18 129
- [3] See Figure 18 130
- 6.2 SPI information units 132
- field shall be reserved 135
- field is not zero 135
- 129 143
- 7.0 SCSI commands 145
- See notes following Table 61 148
- 7.3 Status 152
- 7.4 Command examples 154
- 7.5 Timing examples 156
- 7.8 Parameter rounding 163
- 8.0 Drive features 165
- Command, Message, and Status 168
- (Bits 14 171
- Seagate Technology LLC 186
Related products and manuals for Hardware Seagate Ultra 160
(2 pages)
(50 pages)
(52 pages)© 2020, manymanuals.com. All rights reserved. | 0.779 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals