Seagate Elite 9 Installation Guide download pdf (Page 5)

Elite 23 Installation Guide, Rev. A 3

• Follow the precautions listed above in “Electrostatic discharge

protection.”

• Do not remove any circuit boards from the drive. Return the

entire drive for depot repair if any circuit board is defective.

Removal of circuit boards by personnel not performing depot

repair will damage components and may void the warranty.

• Return the entire drive for depot repair if the HDA is defective.

• Do not attempt to disassemble the HDA. It is not field repair-

able. If the sealed HDA is opened by personnel not performing

depot repair, this will damage components and void the

warranty.

As a component, this drive is designed to be installed and oper-

ated in accordance with UL1950, EN60950, CSA C22.2 950-

M89, and VDE0805.

Seagate takes all reasonable steps to ensure that its products

are certifiable to currently accepted standards. Typical applica-

tions of these disc drives include customer packaging and sub-

system design. Safety agencies conditionally certify component

assemblies, such as the Elite disc drive, based on their final

acceptability in the end-use product. The subsystem designers

are responsible for meeting these conditions of acceptability in

obtaining safety-regulatory agency compliance in their end-use

products and for certifying where required by law. A necessary

part of meeting safety requirements is the provision for overcur-

rent protection on drive SELV supply voltages.

This unit is a component part and as such is not meant to comply

with FCC or similar national requirements as a stand-alone unit.

Engineering radiated emissions test results are available

1 2 3 4 5 6 7 8 9 10 ... 47 48

No comments

Seagate Elite 9 Installation Guide Page 5