Seagate ST118202LC Service Manual download pdf (Page 79)

U26140-J-Z146-3-76 69

4 mm Autoloader Status and error messages

Operator Attention Required LED is flashing amber

Error

message

Meaning Status/action

Bad Media A READ or SPACE command

has failed because the tape

is not in DDS format.

Use a DDS tape.

Clean Me A high error rate has been

detected reading or writing.

Insert a cleaning cartridge to

clean the read/write heads.

Close Door The front panel door is open.

Any autoloader motion will be

delayed.

Close the front panel door.

Eject Fail An eject command has failed. Use a new cartridge, or try

forcing an eject. See the

section “Forcing ejection” on

page 62

FW Data Err The autoloader has failed to

upgrade the firmware

because the new firmware is

corrupt.

Obtain a good copy of the

firmware upgrade.

Force Eject A force eject is in progress. See the section “Forcing

ejection” on page 62.

FW Read Fail A firmware upgrade failed

because of an error in

reading data from the tape.

Try again. If it still fails, notify

your corresponding Service.

FW Tape Write

Protected

A firmware upgrade failed

because the tape is write-

protected.

Change the write-protect tab

on the cartridge and try again.

FW Write Fail A firmware upgrade failed

because of an error in writing

a modified upgrade count to

the tape.

Try again, if it still fails, notify

your corresponding Service.

Illegal FW The autoloader has failed to

upgrade the firmware

because the new firmware is

incompatible.

Obtain a correct version of the

firmware upgrade.

1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 111 112

Comments to this Manuals

No comments

Seagate ST118202LC Service Manual Page 79

Comments to this Manuals