Seagate ST118202LC Service Manual download pdf (Page 93)

U26140-J-Z146-3-76 83

Equipment care Cleaning cartridge tape drives

10.2.3 Cleaning the 8 mm cartridge tape drive

If the error indicator flashes (on MTC drive 8 mm 7 Gbyte) or glows (on MTC

drive 8 mm 20 Gbyte), you should clean the drive as soon as possible, since

even small amounts of dust can impair the functioning of the drive.

You should clean the drive at least once a month or after a maximum of 30

hours’ use.

V Only use cleaning cartridges that have been approved by Fujitsu

Siemens Computers and EXABYTE. Otherwise, the magnetic heads of

the drive may be damage

The following cleaning cartridges should be used:

– for MTC drive MC15: Premium cleaning cartridge 18c

– for MTC drive MC75: Mammoth cleaning cartridge 18c

Depending on its type, a cleaning cartridge must only be used 12 or 18 times

(Premium), or 18 times (Mammoth).

Do not exceed the maximum number of permissible cleaning procedures.

Otherwise, the drive or the read/write heads may be damaged.

Clean the 8 mm MTC drive as follows:

Ê Insert the cleaning cartridge.

Depending on the operating system, either cleaning starts automatically or you

must enter the following command at shell level:

Ê clean8mm devicename

This starts the cleaning operation. The operation takes approx. 1-2 minutes.

Once the cleaning operation is complete, the cleaning cartridge is ejected

automatically.

Ê Remove the cleaning cartridge.

Ê Note the date on the label provided.

This completes the cleaning operation.

You will find further information on cleaning on the cover of the cleaning

cartridge.

1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 111 112

No comments

Seagate ST118202LC Service Manual Page 93