Seagate Elite 9 User Manual download pdf (Page 31)

Connecting the system I/O cabling

Be sure that the site has been prepared in accordance with the site requirements

information provided earlier in this section.

This procedure describes how to cable the system in a daisychain configuration.

This configuration was discussed earlier in this section under “Interface require-

ments.”

The drive has one I/O connector (J06) on the control board. Figure 11 shows how

a typical I/O cable connects to the board.

If the drive is either the first or last device (at either end) in the daisychain, it must

be terminated. Drives in the middle of the daisychain must not be terminated.

Drives that are terminated have two terminator resistor-paks installed.

Daisychain

I/O Cable

Pin 1

I/O

Connector

J06

Figure 11. I/O cable attachment

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 48 49

No comments

Seagate Elite 9 User Manual Page 31