Seagate Elite 9 User Manual download pdf (Page 41)

Operating instructions

Following initial checkout, the drive normally requires no attention from the

operator. DC power is available to the drive, as the on/standby switch on the

power supply is normally left in the on ( l ) position.

If you wish to verify that the drive has completed its power on sequence, gain

access to the drive, and check that its Ready LED is on steady and that the

Heartbeat LED is blinking (see Figure 16).

If the Start Command option was selected (via a control board jumper), the

Stop/Start Unit command must be used to start and stop the drive.

If the Start Command option was not selected, once the drive has been

started, the Stop/Start Unit command can be used to stop and later restart the

drive.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 47 48 49

No comments

Seagate Elite 9 User Manual Page 41