Seagate TS-251-4G User Manual download pdf (Page 91)

3. Click "Finish" after the NAS has added the Wi-Fi network.

4. To edit the IP address settings, click the "Edit" button. You can select to obtain the

IP address automatically by DHCP or configure a fixed IP address.

If the Wi-Fi connection is the only connection between the NAS and the router/AP, you

must select "WLAN1" as the default gateway in "Network" > "TCP/IP" page. Otherwise,

the NAS will not be able to connect to the Internet or communicate with another

network.

Note:

The WEP key must be exactly 5 or 13 ASCII characters; or exactly 10 or 26

hexadecimal characters (0-9 and A-F).

If you have trouble connecting to an encrypted wireless network, check the

wireless router/AP settings and change the transfer rate from "N-only" mode to

"B/G/N mixed" or similar settings.

Users of Windows 7 with WPA2 encryption cannot establish ad-hoc connection

with the NAS. Please change to use WEP encryption on Windows 7.

A fixed IP address is required for the wireless interface in order to establish an ad-

hoc connection.

IPv6

The NAS supports IPv6 connectivity with "stateless" address configurations and RADVD

(Router Advertisement Daemon) for IPv6, RFC 2461 to allow the hosts on the same

subnet to acquire IPv6 addresses from the NAS automatically. The NAS services which

support IPv6 include:

Remote replication

Web Server

FTP

iSCSI (Virtual disk drives)

SSH (putty)

To use this function, select the option "Enable IPv6" and click "Apply". The NAS will

restart. After the system restarts, login the IPv6 page again. The settings of the IPv6

interface will be shown. Click the "Edit" button to edit the settings:

IPv6 Auto C onfiguration:

If an IPv6 enabled router is available on the network,

select this option to allow the NAS to acquire the IPv6 address and the

1 2 ... 86 87 88 89 90 91 92 93 94 95 96 ... 312 313

No comments

Seagate TS-251-4G User Manual Page 91