Seagate TS-251-4G User Manual download pdf (Page 23)

2.2.2 Cloud Installation

Follow the steps in this section to complete cloud installation for your NAS:

1. Connect your NAS to the Internet, and on your PC, go to "start.qnap.com" and click

"Cloud Installation". Alternatively, you may scan the QR code using your mobile

phone to start cloud installation.

2. Enter the cloud key (cloud key can be found from the sticker on top of your QNAP

NAS) and click "Enter". Before proceeding to Step 4, please be sure to activate your

myQNAPcloud account after your account registration is confirmed (an email will be

sent to the email address provided to create your myQNAPcloud account, and the

account activation link will be included in that email.) For details, please refer to the

chapter on myQNAPcloud Service in this manual.

3. Fill out all fields to register your myQNAPcloud account or sign in your myQNAPcloud

account. check "I agree to myQNAPcloud Terms of Use and QNAP Privacy Policy"

and click "Next Step". If you already have a myQNAPcloud account, please select

"Sign in myQNAPcloud account" and login with your account credentials.

4. Type in the name of your Turbo NAS to register it and click "Register".

5. Install a hard drive on your Turbo NAS if you have not already done so.

6. Click "Begin" to install firmware on your Turbo NAS.

7. Click "Start" to start the quick setup.

8. Confirm all details and click "Proceed".

9. Follow the onscreen instructions.

10.Click "Connect and Login QTS".

11.Key in the user ID and password to login your Turbo NAS.

Note:

If you encounter the "Device not found" message on screen, please make

sure:

1. Your NAS has been powered on;

2. the network cable is connected to the NAS and the orange and green indicator

lights on its LAN port(s) are blinking; and

3. The cloud key is correct.

227

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 312 313

No comments

Seagate TS-251-4G User Manual Page 23