79
To restore an iSCSI LUN to the NAS, follow the steps below:
1. Go to "Storage Manager" > "iSCSI" > "LUN Backup". Click "Create a job".
2. Select "Restore an iSCSI LUN" and click "Next."
3. Specify the protocol, IP address/host name, and folder/path of the restore source.
Click "Test" to test the connection. Then click "Next".
4. Browse and select the LUN image file and click "Next."
5. Select the destination and click "Next".
6. The settings will be shown. Enter a name for the job or use the one generated by
the NAS. Click "Next".
7. Click "Finish" to exit.
The restore job will be executed immediately.
View the job status and logs.
Note:
For Step 5 above:
Overwrite existing LUN: Restore the iSCSI LUN and overwrite the existing LUN on
the NAS. All the data on the original LUN will be overwritten.
Create a new LUN: Restore the iSCSI LUN to the NAS as a new LUN. Enter the
name and select the location of the new LUN. Make sure you have created at
least one LUN on the NAS before editing the default LUN policy.
Creating iSCSI LUN Snapshots
Before creating an iSCSI LUN snapshot, make sure at least one iSCSI LUN and one iSCSI
target has been created on the NAS. To create iSCSI targets and LUN, go to "Storage
Manager" > "iSCSI" > "Target Management".
To create an iSCSI LUN snapshot, follow the steps below:
1. Go to "Storage Manager" > "iSCSI" > "LUN Backup". Click "Create a job".
2. Select "Create a LUN Snapshot" and click "Next".
3. Select an iSCSI LUN on the NAS. Only one snapshot can be created for each iSCSI
Comments to this Manuals