Seagate TS-251-4G User Manual download pdf (Page 96)

4.5 Hardware

Go to "Control Panel" > "System Settings" > "Hardware" to configure the hardware

functions of the NAS.

General

Enable configuration reset switch:

When this function is turned on, you can

press the reset button for 3 seconds to reset the administrator password and the

system settings to default (the disk data will be retained), or 10 seconds for

advanced system reset.

Basic system reset (3 sec):

After pressing the reset button for 3 seconds, a beep

sound will be heard. The following settings will be reset to default:

System administration password: admin.

TCP/IP configuration: Obtain IP address settings automatically via DHCP.

TCP/IP configuration: Disable Jumbo Frame.

TCP/IP configuration: If port trunking is enabled (dual LAN models only), the port

trunking mode will be reset to "Active Backup (Failover)".

System port: 8080 (system service port).

Security level: Low (Allow all connections).

LCD panel password: (blank); This feature is only provided by the NAS models

with LCD panels. Please visit http://www.qnap.com for details.

VLAN will be disabled.

Service binding: All NAS services run on all available network interfaces.

1 2 ... 91 92 93 94 95 96 97 98 99 100 101 ... 312 313

No comments

Seagate TS-251-4G User Manual Page 96