Seagate ST39173WC Specifications Page 77
- Page / 122
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
Chapter 5 Maintenance and Service 5-7
5.1.5 SCSI ID Jumper Settings
The controller module SCSI ID can be changed, if necessary, by the use of jumpers.
The SCSI ID jumper block is located at the rear of the SCSI controller module. See
Section 2.3 “Verifying Controller Module ID Settings” in the Sun StorEdge
A3500/A3500FC Hardware Configuration Guide for detailed instructions. The factory
default settings are shown in
TABLE 5-1.
5.1.6 SCSI Termination Power Jumpers
There are two SCSI termination power jumpers located at the rear of the SCSI
controller module. One is located below and to the left of the J11 connector (DIFF
SCSI ARRAY 1). The other is located below and to the right of the J4 connector (DIFF
SCSI HOST B). These jumpers enable the controller boards to supply SCSI
termination power to the host SCSI bus. Do not remove these jumpers.
5.1.7 LED Indicators
See Section 4.1 “Checking the Controller Module LEDs” in the Sun StorEdge
A3500/A3500FC Controller Module Guide for detailed information on checking the
controller module LEDs.
5.1.8 Backplane Assembly
Backplane failures are rare. There are no active devices on the backplane.
5.1.9 D1000 FRUs
Refer to the following web site for a listing of the D1000 FRUs:
http://infoserver.central/data/syshbk
TABLE 5-1 Controller Module SCSI ID Settings
Controller SCSI ID
A5
B4
- Sun StorEdge 1
- A1000 and 1
- A3x00/A3500FC Best Practices 1
- Contents 3
- Contents v 5
- Contents vii 7
- Figures ix 9
- Tables xi 11
- Before You Read This Book 13
- How This Book Is Organized 14
- Using UNIX Commands 14
- Typographic Conventions 15
- Shell Prompts 15
- Related Documentation 16
- Accessing Sun Documentation 17
- Sun Welcomes Your Comments 17
- Troubleshooting Overview 19
- A3x00/A3500FC disk array 20
- 1.2.1 Documentation 21
- 1.2.2 Web Sites 22
- 1.2.3 Internal Directory 22
- Supported 23
- 1.2.6 Serial Cable 23
- 1.3 Tips for Filing a Bug 24
- 1.4 FINs and FCOs 24
- Date Product Description 25
- Hardware Installation and 31
- Configuration 31
- 2.1 New Installation 32
- 2.1.3 Power Sequencer 33
- 2.1.4 Local/Remote Switch 33
- Switch Settings 34
- 2.1.7 World Wide Name (WWN) 35
- Existing A3x00 Arrays 36
- Chaining Configurations 40
- 2.7 Supported Configurations 41
- 2.7.2 Onboard SOC+ 42
- 2.7.6 HBAs 43
- 2.8 SCSI to FC-AL Upgrade 44
- RAID Manager Installation and 45
- 3.1.1 Software Installation 46
- 3.1.2 Software Configuration 47
- 3.2 LUN Creation/RAID Level 49
- 3.2.2 LUN Numbers 50
- 3.2.3 The Use of RAID Levels 50
- 3.2.4 Cache Mirroring 50
- 3.2.5 Reconstruction Rate 51
- 3.2.7 DacStor Size (Upgrades) 52
- 3.4.1 NVSRAM Settings 53
- 3.4.2 Parity Check Settings 54
- 3.4.2.3 Parity Repair 55
- 4.1 Installation 58
- 4.2 Solaris Kernel Driver 58
- 0 0x0 0x0 0x0 0xe 0x12 59
- 4.3 format and lad 60
- 4.3.1 Volume Labeling 61
- 4.4.1 Removing Ghost Drives 64
- 4.5 Device Tree Rearranged 65
- 4.5.1.1 Workaround 66
- 4.6 SNMP 67
- Managers 68
- 4.7.3 Sun Cluster 69
- 4.7.4 High Availability (HA) 69
- 4.7.5 Quorum Device 70
- Maintenance and Service 71
- 5.1.1 Disk Drives 73
- 5.1.2 Disk Tray 74
- 5.1.3 Power Sequencer 75
- 5.1.4 SCSI Cables 76
- 5.1.5 SCSI ID Jumper Settings 77
- 5.1.7 LED Indicators 77
- 5.1.8 Backplane Assembly 77
- 5.1.9 D1000 FRUs 77
- 5.1.10 Verifying the HBA 78
- A3x00/A3500FC 78
- 5.1.12 Controller Board LEDs 79
- 5.2 FRU Replacement 80
- 5.2.2 Interconnect Cables 81
- 5.2.3 Power Cords 81
- 5.2.4 Power Sequencer 81
- 5.2.5 Hub 82
- 5.2.8 Battery Unit 83
- 5.2.7 Amount of Cache 83
- 5.2.9 Cooling 84
- 5.2.10 Disk Drives 84
- 5.2.11 Disk Tray 84
- 5.2.12 Midplanes 85
- 5.3.2 RAID Manager 6 Upgrade 88
- 5.3.3 Firmware Upgrade 88
- How to Recover 92
- 6.2 LUNs Not Seen 96
- Reinitialization 97
- VKI_EDIT_OPTIONS 100
- 6.4 Dynamic Reconfiguration 101
- Takes Too Long 102
- 6.6 GUI Hang 103
- Problems 103
- Manager 6.22 104
- is running 107
- reading past the end of the 107
- Reference 109
- A.1 Scripts and man Pages 110
- Information for CPRE/PDE 111
- PCI/SBus Systems 112
- A.4 A3500/A3500FC Electrical 113
- Specifications 113
- A.5 Product Names 115
- NVSRAM Product ID 116
- NUMERICS 117
- command, 6–17 119
© 2020, manymanuals.com. All rights reserved. | 0.127 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals