The Settings Tab
Figure 36 - The Settings Tab
The ‘Settings’ tab provides the ability to change
default settings for SCSI Hammer™ actions.
Changes made here are saved on the device in
NVRAM.
SCSI Hammer™ Notes:
Any SCSI Bus ID conflict, including setting
SCSI Hammer™ to the same SCSI ID as a
drive attached to either ‘Side’ of the
device, will result in unexpected behavior.
One known behavioral characteristic is that
the LCD will show devices connected at
*every* SCSI ID, even if not all IDs are
occupied.
To restore factory default settings, use the
‘Restore Defaults’ button. Figure 36 depicts the
Settings Tab showing default values. These are:
• Bang
o This indicates the method of
erasure. Users may select 'Security
Erase' using the drop-down menu
• Verify Command
o [Disabled by default]
• Print Labels
o Optional Bluetooth printer required. [Disabled by default]
• Clear HPA
o [Enabled by default]
• PowerOn Timeout (ms)
o Default Value: [20,000]
• Command Timeout (ms)
o Default Value: [4,000]
• Bluetooth Timeout (ms)
o Default Value: [50,000]
• FPGA Retry Count
o Default Value: [3]
• Bus ID Number
o Default Value: [7]
SCSI Hammer™ Users Guide
Page 65 of 89
Comments to this Manuals